Dragster Conversion Chassis For Traxxas - Rear Motor - Full Kit
Full Dragster Conversion kit for Traxxas slash2wd ,rustler and bandit -
Kit includes -
3mm thick 2 part design chassis plate , chassis edge rail brace kit , front end center stabilization kit, esc plate kit, 2s/3s Battery mount kit, 6" Flat 3mm Wheelie bar kit (Traxxas Turnbuckle not included) screws/nuts/spacers hardware, aluminum brace spacers , aluminum screw on body posts, Front and rear Delrin 6mm low profile sleek shock towers , center upper deck Plate , front axle screws to use Traxxas funny car front wheels and both ESC , Battery lock down brace tie ins braces and NS (No slop) bell crank Cross link and bearings.
(See Link for assembly videos) https://www.youtube.com/playlist?list=PLf2IMKOHcnrkf8sefBoZMB3WCaEBC93Bj
22 1/4" WB
Adjusting rear or front track width can be done using either Slash 2wd/rustler/bandit or 4tec suspension arms. Note: If using our Rigid front end kit you must use bandit front arms. Rear Axles MIP #10130 With bandit arms direct bolt on steel.
Aluminum upgrades you see in pictures not included (See Integy.com for those)
Requires to complete-
Traxxas TRA3644 turnbuckle for steering bell crank to servo & for the wheelie bar to a Hot racing or Integy Transmission case NOTE if using stock Traxxas transmission case choose Ladder bar wheelie bar choice for RPM motor mount(39mm turnbuckle/70mm center to center) servo mounts single post style.
Check out our Fantom Racing Motors and 2s Graphene Batteries
Designed for Rj Speed 24" Dragster body Part # RJS1007 (Not included) Bodies are sold by http://rccarkings.net/drag%20page.html You can also use 30" WB Dragster bodies like RJ speed 30" and remove section behind driver compartment if you don't want the engine part of body.
Use a Slash 2WD , Bandit or Rustler gear box ,front bulkhead/arms, caster blocks /knuckles and caster turnbuckles and slash 2wd or bandit rear shocks. Front low profile shocks use 4tec 2.0 shocks. Standard sized steering servo (Standard Low profile servo recommended) , Bell crank assembly (Comes with new mounting hardware). Requires 2s or 3s Battery. Electronics ,Radio, rear & front wheels.
Recommended front wheels traxxas weld aluminum wheels #TRA6969 or our aluminum front skinny drag rims and for rears either jconcepts 1/10 rear buggy smoothies or 1/10 rear buggy proline primes on 2.2 rims or 1/10 aluminum 2" drag rims and adapters. You may also bolt on xceed 12mm hex carbon foams or BSR 12mm hex foams.
Kits can take few days to few weeks to cnc and ship. All based on timing of order and how backed up we are when placed. Tracking gets emailed when shipped.